How to Replace the Display Enclosure | HP ENVY 13-j000 x2 Detachable PC | HP


Note: The following video depicts a specific configuration of the notebook. The same removal and replacement procedures apply to all configurations of the notebook. Before you begin: Remove the recess cover. Removal Remove the four 3 mm P1 Phillips-head screws from the recess in the display panel assembly. Remove the five 3 mm P1 Phillips-head screws from under the display stand. Remove the two screw covers from the bottom edge of the display assembly. Remove the two 3 mm P1 Phillips-head screws from the bottom edge of the display panel assembly. Remove the two 2.5 mm P0 Phillips-head screws from the bottom edge of the display panel assembly. IMPORTANT: If you have access to suction cups, follow the best practices outlined in the Maintenance and Service Guide. The following steps are performed without access to these tools. Using a non-marring flat-bladed tool, carefully release the display enclosure from the display panel assembly. CAUTION! To prevent damage to the display enclosure, take extreme care when the non-marring flat-bladed tool is near any of the external buttons or connectors. Remove the display enclosure. Replacement Place the display enclosure onto the display panel assembly and apply pressure to the edges of the display enclosure to secure it into position. Replace the two 2.5 mm P0 Phillips-head screws into the bottom edge of the display panel assembly. Replace the two 3 mm P1 Phillips-head screws into the bottom edge of the display panel assembly. Replace the two screw covers into the bottom edge of the display panel assembly. Replace the five 3 mm P1 Phillips-head screws under the display stand. Replace the four 3 mm P1 Phillips-head screws into the recess in the display panel assembly.

Leave a Reply

Your email address will not be published. Required fields are marked *